Configure between passive and active types
Overview Signal conditioning SLSC
The SMARTbrick 2200A module can be used to configure passive and active types. For error stimulations, a line break / short-circuit on line can be stimulated individually for each of the two channels per module. The configuration and the error stimulation are specified in connection with the carrier board via CAN bus.
SKU: 85282
| Channels | 2 |
| Output voltage | 24 VDC |
| Max. output current | 10 mA |
| Max. allowed current through switches | 200 mA |
| Resistance with the switch closed | max. 3.5 Ω |
| A to switch lying parallel switchable resistor ( RD ) is used to simulate a wire break. The impedance of the resistor is freely configurable. | |
| Error stimulation „line break“ | via software |
| Resistance value | 24 kΩ |
| Insulation voltage | max. 50 VDC |
| Insulation resistance | > 1MΩ |
| Configuration | active / passive via software |
| Display of configuration | via LED’s |