SMARTbrick 2200A – DUAL SOLID SWITCH/SOURCE2018-11-12T10:05:24+00:00

SMARTbrick 2200A – DUAL SOLID SWITCH/SOURCE

Configure between passive and active types

  • SET SMARTbrick Dual Solid State Switch
The SMARTbrick 2200A module can be used to configure passive and active types. For error stimulations, a line break / short-circuit on line can be stimulated individually for each of the two channels per module. The configuration and the error stimulation are specified in connection with the carrier board via CAN bus.
Channels2
Active state
Output voltage24 VDC
Max. output current10 mA
Passive state
Max. allowed current through switches200 mA
Resistance with the switch closedmax. 3.5 Ω
Modulfunctions
A to switch lying parallel switchable resistor ( RD ) is used to simulate a wire break.
The impedance of the resistor is freely configurable.
Error stimulation “line break”via software
Resistance value24 kΩ
Insulation voltagemax. 50 VDC
Insulation resistance> 1MΩ
Configuration active / passive via software
Display of configurationvia LED’s

Additional Products

SET-14XX Modular Cards
SLSC-14XX Modular Cards

Contact

You have questions? Our team is always happy to answer your questions: +49 7522 916 87 600
Or just write an E-Mail to smartbrick.support@smart-e-tech.de.